premise that all Acer notebooks are fitted with the same technique and subject to some minor changes are very similar to each other also in the disassembly.
Importantly, if you are no longer practical to do not you put this kind of operations that are very delicate:
you need: 1 screwdriver
a small screwdriver small
Compressed air (compressor or canister)
Pasta thermoconductive should you replace the heatsink with isopropyl alcohol
fan, I have always used this to remove the pulp.
levaciglia
The screwdriver Tweezers tweezers and it is good that they are magnetized so as not to drop the small screws that will be collected and broken down by groups of assembly, a small tool to sell hardware magnetized and demagnetized, you'll always need in the future.
a) Remove the two units of plastic pins that hold the monitor
b) a Phillips screwdriver to remove the two or more small screws that hold the mask under the monitor.
c) Remove the cover from the back of the notebook with a flat screwdriver.
d) Remove the mask by releasing the two side pins in contact with the keyboard.
e) remove the keyboard. The hooks are just side then bend a little to release it, being careful not to distort
f) you will see that you get to the heatsink, possibly to remove remove the 6 / 7 presenti.Soffiare screws on the fan with compressed air and ventilation openings. Remove all dust. I do not think you will need to remove your case and if I wanted to do, take out the thermal paste with isopropyl alcohol and proceed to fix it with the dough as in any desktop machine.
When reassembling make special attention to the tiny screws. Helped with the tweezers, again magnetized to prevent them from dropping it would be a real problem.
The problem of the heat of a laptop does not depend only
from dust or other accumulating all'interno dei
condotti di ventilazione che comunque è bene tener puliti utilizzando un compressore o in alternativa delle bombolette d'aria compressa.
Spesso il surriscaldamento è dovuto alla scarsa areazione, in quanto le
ventole pescano l'aria da sotto il portatile dove lo spazio è minimo.
La cosa migliore è sollevare il
portatile, sopratutto la parte posteriore, utilizzando o una semplice stecca di legno o degli appositi sostegni che trovi in vendita dappertutto cha assomigliano a leggii musicali.
Ripeto ancora devi avere una certa manualità per fare queste operazioni che sono comunque molto delicate e da sconsigliare sempre.
0 comments:
Post a Comment